BLWNN - ELAST-A-TRIM GL HSE & TRM 6900

  • MSDS: BLWNN
  • Manufacturer: EVR GARD COATINGS CO
  • Product Name: ELAST-A-TRIM GL HSE & TRM 6900
  • National Stock Number: 8010-00N017978
Product Identification

Product ID:ELAST-A-TRIM GL HSE & TRM 6900
MSDS Date:01/01/1989
FSC:8010
NIIN:00N017978
MSDS Number: BLWNN

Responsible Party
EVR-GARD COATINGS CO
16400 GARFIELD AVE
PARAMOUNT, CA 90723
US

Emergency Phone: 213-531-0131

Info Phone: 213-531-0131

Cage: 5G582

Contractor
EVR-GARD COATINGS CO
PARAMOUNT, CA 90723 US

Telephone: 310-531-0131

Cage: 5G582

Ingredients

5.0 @ 68F.

Fraction By Weight: 62.75%

OSHA PEL 125 PPM (MFR)

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL: IRRITATION OF NOSE, THROAT &
EYES, DIZZINESS, WEAKNESS, FATIQUE, NAUSEA, HEADACHE. SYMPTOMS
DIAPPEAR WHEN EXPOSURE CEASES. EYE/SKIN: MAY CAUSE IRRITATION.
REPORTS HAVE SHOWN THAT REPEATED & PRO LONGED OCCUPATIONAL
OVEREXPOSURE TO SOLVENTS CAN CAUSE PERMANENT BRAIN DAMAGE & NERVOUS
SYSTEM DAMAGE.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:INHAL: EXCESSIVE INHAL OF VAPS MAY RSLT IN
DIZZ/HDACH. UNCON IN EXTREME CASES. SKIN CONT/ABSORPTION: IRRITANT.
AFFECTED AREA WILL SHOW SIGNS OF REDNESS & RASH IF NOT WASHED
W/SOAPY WATER IMMED. APPLY LOTION/OIL TO AFFECTED AREA AFTER
THOROWASHING. INGEST: IRRIT OF RESP TRACT CHARACTERIZED BY
HDACH/DIZZ/ (SUPP DATA)
Medical Cond Aggravated by Exposure:PROLONGED OR REPEATED CONTACT MAY
CAUSE DERMATITIS.

First Aid

First Aid:INHAL: REMOVE PATIENT TO FRESH AIR. EYE: FLUSH W/PLENTY OF
WATER FOR AT LEAST 15 MINUTES. SKIN: REMOVE SOAKED CLOTHING & WASH
SKIN W/SOAPY WATER THOROUGHLY. INGEST: DO NOT INDUCE VOMITING. CALL
MD IMM EDIATELY.

Fire Fighting

Lower Limits:1.0%
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:FIGHT AS VOLAT LIQ FIRE. CLOSED CONTRS MAY
EXPLODE WHEN EXPOSED TO EXTREME HEAT. KEEP AWAY FROM AREAS EXPOSED
TO FIRE. WEAR NIOSH/MSHA APPRVD SCBA & (SUPP DATA)
Unusual Fire/Explosion Hazard:AVOID APPLICATION IN AREAS OF PILOT
LIGHT, SPARKS OR OTHER IGNITION SOURCES AS VAPS MAY ACCUMULATE ON
FLOOR & IGNITE. KEEP CONTRS CLOSED TIGHTLY & (SUPP DATA)

Accidental Release

Spill Release Procedures:ABSORB SPILLED MATERIAL WITH ABSORBENTS, SUCH
AS SAWDUST, CLAYS, ETC., & FLUSH SPILL AREA WITH LOTS OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:DO NOT STORE NEAR OPEN FLAME/SOURCES
OF IGNITION. DO NOT STORE IN HIGH TEMP STORAGE. IN CASE OF FIRE,
REMOVE CLOSED CONTRS FROM AREAS EXPOSED TO FIRE.
Other Precautions:EMPTY CONTRS USUALLY STILL HOLD RESIDUES OF MATERIAL
& VAPORS. THESE MUST BE CONSIDERED HAZARDOUS & DISPOSED OF IN
ACCORDANCE W/PROPER HANDLING PROCEDURES PRESCRIBED FOR HAZARDOUS
CHEMICALS.

Exposure Controls

Respiratory Protection:USE OF OSHA APPRVD RESP IS RECOM WHEN USING SOLV
BASED COATINGS. WHEN THE LEVEL OF SOLV VAPS IS NOT KNOWN/EXCEEDS
THE LEVEL AT WHICH REGULAR RESP ARE EFFECTIVE, THE USE OF OSHA
APPRVD RESP SUCH AS TC- 19C-NIOSH-MSHA IS HIGHLY RECOMMENDED.
Ventilation:BE SURE TO PROVIDE ADEQ VENT IN ALL WORKING AREAS AT ALL
TIMES. SERIOUS HLTH PROBLEMS COULD RSLT FROM RPTD/PRLNG EXPOS.
Protective Gloves:NEOPRENE, BUNA N, (SUPP DATA)
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:STANDARD HYGIENIC PRACTICES MUST BE OBSERVED
WHEN HANDLING THIS PRODUCT & ALL CHEMICALS.
Supplemental Safety and Health
FIRE FIGHT PROC: FULL PROT EQUIP . EXPLO HAZ: STORE IN A COOL PLACE
WHEN NOT IN USE. EFTS OF OVEREXP: STAG/CONFUSION & UNC & COMA IN
EXTREME CASES. PROT GLOVES: IF NECESSARY TO PREVENT PROLONGED OR
REPEATED CONTACT.

Chemical Properties

HCC:V4
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:1.2
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NOT SOLUBLE
Appearance and Odor:WHITE PAINT-COLORS - PAINT THINNER ODOR.

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALIS. LONG TERM CONTACT WITH WATER.
Stability Condition to Avoid:AVOID OPEN FLAMES, WELDING ARCS OR OTHER
HIGH TEMPERATURE SOURCES WHICH INDUCE THERMAL DECOMPOSITION & FIRE.
Hazardous Decomposition Products:THERMAL DECOMPOSITION MAY YIELD CARBON
DIOXIDE &/OR CARBON MONOXIDE.

Disposal

Waste Disposal Methods:DISPOSE OF ALL WASTES, INCLUDING ABSORBENTS USED
TO CLEAN UP SPILLS INTO 55-GAL METAL CONTRS & DISPOSE IN APPROVED
DUMPSITE IN ACCORDANCE WITH PRESCRIBED FEDERAL, STATE, AND LOCAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.